#Docker nzbget how to
#Docker nzbget update
#Docker nzbget password

Once you are logged in type ‘id nameofuser’ (without the quotes) and the ‘nameofuser’ will be the name of the user you created earlier.

#Docker nzbget password

Please note that you will not be able to see the password as you type it. You may get a prompt asking if you trust the key, just press OK or accept.Įnter the login information for your admin Synology user account. Within your SSH application, enter the IP address of your NAS and select the SSH protocol. This is found in the “Terminal and SNMP settings. Go into the Control Panel again and enable SSH. Now that you have created your container user, you will need the PUID and PGID for configuring NZBGet.įirst, you will need to SSH into your Diskstation using PuTTY, WinSCP, or similar. Once confirmed click on ‘Apply’ and your user has been created. Be sure that the correct shares are in the ‘Writeable’ list. Now on the confirmation page, review and confirm your settings are correct. Ignore all settings in the Speed Limit settings. On the permissions setting screen check the ‘Deny’ button at the top of the column, this will check all as “Deny”. Ignore all settings in the user quota settings. Once your settings are selected click next. In all instances, it requires access to the Docker share. You can customize this as needed by your setup. Now we need to grant access to the specific shares required. This prevents it from being used for admin access. Inside the DSM control panel navigate to the ‘User’ setting and click “Create”.Įnter the username and password of your choosing, and click on next. If you are unfamiliar with Synology’s DiskStation Manager we suggest reviewing their documentation before beginning. Please note that this tutorial assumes knowledge of the DSM interface. Once you have completed the steps here go back to the original setup guide you were following. NZBGet - Creating a User in DSM for an NZBGet/Synology Installation Open up a new tab and go to the IP of your NAS and the port number you chose. You can now apply the settings to the container and launch the Docker image. Please note: You do not need to change any settings in Network or Links In the environment tab, enter the details as shown in the screenshot, but change them to whatever yours were noted in the PGID/PUID guide below.Ĭlick OK and this will take you back to the summary screen we saw earlier. The Environment section allows the Docker image to have the right access to the shares we just added. Next click on the “Environment” tab at the top right corner. In this example, we are using 32333 but this can be any port of your choosing, and this effectively port forwards to the container port of 6789.

#Docker nzbget update

It is suggested to change this setting from “Auto” as with that setting in place the port will update upon each restart. This is where we select the local port that NZBGet will use. Review the screenshot below for reference. Next, add your downloads folder, this is wherever you wish to save your downloads to. Your configuration files will be residing here. Under the ‘Docker’ share create a folder called ‘NZBGet’. Next, select the “Volume” tab, this is where we will set up the shares to mount. Now inside the advanced settings area, select the ‘Enable Auto Restart’ so that the container will launch upon reboot. In the General Settings section confirm the name for the container and click on the “Advanced Settings” button. To open the setup wizard click on the “Launch” button on the top of the screen. Select the image menu on the left-hand side:

#Docker nzbget how to

To learn how to do this please review the guide below, then return to this one.

Setting up a Docker User for NZBGet and Obtaining the PGID and PUIDīefore we begin we suggest creating a unique admin account for the setup of NZBGet. Search for “NZBGet” and select the Linuxserver image.ĭownload the image by right-clicking on it and selecting the save dialogue. For this guide, we will use the one available on Linuxserver.io. We will begin the setup by downloading the NZBGet container.